Call 855-502-2244
60A Equipment Disconnect and Breaker Upgrades in Matthews, NC
Completed on April 16, 2026 by technician Mark Viktorovich, this Panels & Service Upgrades project in Matthews, NC focused on safe power isolation and reliable overcurrent protection for a customer-supplied major appliance. Our Charlotte branch team installed a code-required 60-amp equipment disconnect, upgraded breakers in the main panel, resecured the meter enclosure, and handled permitting to keep the project compliant and inspection-ready.
Customer: DAVID MCCORD • Service category: Panels & Service Upgrades and Service Disconnects
What we installed and upgraded
- 60A pull-out equipment disconnect: A dedicated maintenance disconnect to isolate power to the appliance for safe service and repairs.
- New breakers: Installed a 60A standard breaker for the dedicated circuit and a 20A tandem breaker to support a small-appliance load as needed.
- Meter resecured: Corrected a loose meter enclosure by reattaching and stabilizing it for safety and longevity.
- Feeder and raceway: Pulled 15 ft of THHN #6 conductors in 10 ft of 3/4" PVC conduit with appropriate fittings for a clean, protected run.
- Major appliance hookup: Connected a customer-supplied unit during the same visit, providing either hard-wiring or a receptacle as appropriate to the installation.
- Permitting and inspection coordination: Filed the electrical permit with the county and prepared the installation for inspection.
Why this work matters
A properly sized disconnect and correctly rated breakers are essential for both safety and performance. The disconnect provides a clear means to de-energize equipment during maintenance, while the 60A and 20A breakers deliver appropriate overcurrent protection to help prevent nuisance trips and overheating.
- Safety first: A visible, accessible disconnect helps protect anyone servicing the appliance.
- Code alignment: The scope and components were selected to meet current local requirements and inspection standards.
- Reliability: Secure meter mounting and protected conductors in PVC conduit reduce risks from weather, vibration, and wear.
Materials and components used
- Pull-out equipment disconnect rated for ≤60 amps
- 60A standard breaker and 20A tandem breaker
- THHN #6 conductors (15 feet)
- 3/4" PVC conduit with fittings and LBs (10 feet)
These components were chosen to match the load requirements of the major appliance and to provide a clean, serviceable installation at the panel, disconnect, and point of use.
Permits and compliance
Touchstone Electric filed the electrical permit with the county as part of this project. Please note: non-electrical permits (such as Historic Preservation, Environmental/Septic, Zoning, Builder, or other specialized permits) are not included. If additional permits are required by your jurisdiction, we will let you know what is needed and can provide pricing to assist with processing and filing if requested.
Local service in Matthews, NC
From our Charlotte branch, Touchstone Electric proudly serves homeowners in Matthews, NC with panel upgrades, service disconnects, breaker replacements, and safe appliance hookups. Whether you are adding HVAC equipment, a water heater, an indoor spa, or preparing for an EV charger, we can design and install the right circuit, protection, and shutoff solutions for your home.
Reviewed by our customer
We appreciate the feedback on this project—DAVID MCCORD praised our service on Google. Read the review here: Google review for this Matthews project.
Need a similar disconnect or breaker upgrade?
If you are in or around Matthews, NC and need a 60A equipment disconnect, breaker changes, meter corrections, or a code-compliant appliance hookup, our team is ready to help. Request service with Touchstone Electric’s Charlotte branch to get a safe, inspection-ready installation tailored to your home and equipment.