Completed 200A Electrical Panel & Meter Upgrade in Charlotte, NC

Touchstone Electric’s Charlotte team, operating from our Matthews branch, completed a comprehensive 200-amp service upgrade for Native Contracting in Charlotte, NC on April 30, 2026. This project included a new 200A meter base combo, an indoor 200A main panel with new breakers, a robust grounding system, whole-home surge protection, dedicated circuits, lighting upgrades, and new interior/exterior outlets.

Scope of Work

200A meter/panel combo (feed-through) installed and supplied, including coordination of the utility power drop, permitting, and inspection management.
Indoor 200A main panel installed and brought up to current code: bonding and grounding completed, existing circuits reconnected, and panel directory clearly labeled.
New breakers supplied and installed to match load requirements and circuit applications.
Grounding system upgraded with new grounding electrode conductors and ground rods for a low-impedance path to earth.
Whole-home surge protection installed at the service equipment to help guard sensitive electronics and appliances.
Two floor outlets added in the living room for clean, convenient power without extension cords.
Outdoor outlets added at the front and back of the home using weather-appropriate devices and enclosures.
New dedicated circuit for a tankless water heater to support the appliance’s high continuous load.
HVAC line relocation coordinated to maintain proper clearances and streamline the electrical layout.
Lighting upgrades: 12 new can lights supplied and installed, with final can and switch layout coordinated during the rough walk-through.
Bathroom ventilation: new bath exhaust fan supplied and installed for improved moisture control.
New construction rough-in per stamped plans, including branch circuits for kitchen, laundry, dining, and bathrooms; appliance wiring (range, cooktop, microwave, dishwasher, disposal, washer, dryer); device wiring for outlets, lights, and switches; and panel labeling.
SER 4/0 feeder installed from the main panel to a subpanel to ensure proper capacity and code-compliant conductor sizing.
Panel relocation performed as part of the upgrade to optimize accessibility and clearances.

Code Compliance and Safety

All work was completed to current NEC and local Charlotte-Mecklenburg requirements. Our team handled permitting, coordination with the power provider, and inspection scheduling. Where required by the inspector, circuits were configured for AFCI/GFCI protection to meet modern safety standards.

This upgrade enhances system safety, improves fault protection, and provides a clean, organized service area that’s accessible for future maintenance or expansion.

Results for the Home

Reliable 200-amp capacity and modern overcurrent protection.
Cleaner power with whole-home surge protection at the service entrance.
Dedicated high-demand circuits for appliances like the tankless water heater.
Better lighting and ventilation through new can lights and a bath fan.
Convenient power access with new living room floor outlets and exterior receptacles.
Future-ready infrastructure with properly sized feeders and labeled panels.

Meet the Charlotte Installation Crew

Technicians: Will Cruz, Theo Coetsee, Chris Rogers, and Robert Sloan. This team managed the full upgrade from planning and rough-in through final device installation and inspection coordination.

Customer Feedback

Native Contracting praised our team with a positive review following completion of the project.

Serving Charlotte, NC

Touchstone Electric provides expert Panels & Service Upgrades and Electrical Panel Upgrades throughout Charlotte, NC and the surrounding communities. If you’re planning a 200A service or panel replacement, need a dedicated circuit for a new appliance, or want to add lighting and weather-ready exterior outlets, our Matthews-based Charlotte team is ready to help.

200A Electrical Panel & Meter Upgrade Service in Charlotte, NC